M2 — Principal Lunar Semidiurnal
The primary gravitational tide raised by the rotation of the Earth relative to the orbiting Moon twi...
The M4 constituent represents the shallow water first overtide of m2 component in harmonic tidal prediction. In classical analog tide-predicting machines, this partial wave was generated by an oscillating crank and Scotch yoke driven by a designated gear train.
57.968208°/hr6.2103 hours455.55516% of M2Not an astronomical force, but the hydrodynamic distortion of the M2 wave caused by seabed friction and non-linear continuity in shallow water.
Causes asymmetric tides where the flood duration differs drastically from the ebb, sometimes producing a tidal bore.
Rotates at exactly twice the speed of M2 (2 * 28.9841042° = 57.9682084°/hr). Enabled mechanical predictors to forecast "double high waters" and distorted estuarine curves.
Gear Ratio Implementation:
Exact 2:1 gear ratio driven off the M2 primary shaft, eliminating the need for an independent astronomical gear train.
On historic calculators such as US Coast Survey Machine No. 2 ("Brass Brains") and the Bidston Observatory Doodson-Légé machines, each shaft had to maintain exact angular synchronisation with solar clockwork over 8,760 hours of continuous calculation without drifting out of phase.
How did an analog computer technician dial the M4 constituent into a brass tide-predicting machine before a 365-day charting run? Follow the standard hydrographic office protocol:
Analog computers were governed by the laws of friction, backlash, and mechanical tolerances. Operating the M4 constituent presented distinct physical challenges:
| Known Error Source | Observed Mechanical Symptom | Historical Corrective Action |
|---|---|---|
| High-speed shaft vibration on rapid 6-hour rotation | Acoustic chattering of the M4 crank pin at higher operator cranking speeds. | Limit manual crank rotational speed to under 40 RPM when tracing estuarine charts, or damp the Scotch yoke with felt pads. |
For a complete review of analog calculation tolerances, see our study on Friction, Backlash, and Wire Stretch: Where Error Lived in Brass Computers.
Because each body of water resonates with different astronomical frequencies, the amplitude of M4 varies dramatically around the globe:
| Reference Harbor | Typical Amplitude | Local Tidal Characteristics |
|---|---|---|
| Southampton, UK | 0.34 m | Famous "double high water" allowing ships extended docking time without grounding. |
| Havre, France | 0.40 m | Creates a prolonged high-water stand ("tenue du plein") vital for port operations. |
| Anchorage, Alaska, USA | 0.48 m | Intense shallow water distortion driving rapid 10-meter tidal bores in Turnagain Arm. |
Observe how M4 interferes with other harmonic waves on our virtual brass analog synthesizer. Adjust frequency, amplitude, and phase angle interactively.
Launch Harmonic Synthesizer ›Just like overtones in music, when a pure tidal sine wave travels through shallow water where depth is comparable to wave amplitude, it distorts non-linearly, generating harmonics at twice (M4), three times (M6), and four times (M8) the base frequency.
When M4 peaks out of phase with M2, it creates a dip right in the middle of the M2 high-water crest. This transforms a single rounded peak into two distinct high waters separated by a minor drop.
No. Early predictors lacked overtides, which made them incapable of predicting estuarine harbors like London or Southampton until Doodson and Harris added them.
The primary gravitational tide raised by the rotation of the Earth relative to the orbiting Moon twi...
The gravitational tidal force exerted by the Sun as Earth rotates once every 24 mean solar hours....
The variation in lunar distance due to the elliptical eccentricity of the Moon’s orbit as it moves b...
The declination of both the Moon and Sun north and south of Earth’s equator during their orbital cyc...