M2 — Principal Lunar Semidiurnal
The primary gravitational tide raised by the rotation of the Earth relative to the orbiting Moon twi...
The O1 constituent represents the principal lunar diurnal component in harmonic tidal prediction. In classical analog tide-predicting machines, this partial wave was generated by an oscillating crank and Scotch yoke driven by a designated gear train.
13.943036°/hr25.8193 hours145.55541.5% of M2The Moon’s orbital motion combined with its declination relative to the Earth’s equator.
Maintains relatively stable linear propagation across shallow shelves, helping identify bottom boundary layer dissipation when compared to M2.
Beats against K1 over a 13.66-day cycle to produce the tropical tide variation (shifting between equatorial semidiurnal and tropical diurnal tides).
Gear Ratio Implementation:
Models 13.9430356°/hr; requires high reduction gearing off the solar drive train.
On historic calculators such as US Coast Survey Machine No. 2 ("Brass Brains") and the Bidston Observatory Doodson-Légé machines, each shaft had to maintain exact angular synchronisation with solar clockwork over 8,760 hours of continuous calculation without drifting out of phase.
How did an analog computer technician dial the O1 constituent into a brass tide-predicting machine before a 365-day charting run? Follow the standard hydrographic office protocol:
Analog computers were governed by the laws of friction, backlash, and mechanical tolerances. Operating the O1 constituent presented distinct physical challenges:
| Known Error Source | Observed Mechanical Symptom | Historical Corrective Action |
|---|---|---|
| Inadequate pulley counterweight causing cable slack during diurnal troughs | Pen sticks or skips during deep daily low waters. | Increase the counterweight mass at the terminal wire anchor by 50–100 grams to guarantee positive tension across all 37 pulleys. |
For a complete review of analog calculation tolerances, see our study on Friction, Backlash, and Wire Stretch: Where Error Lived in Brass Computers.
Because each body of water resonates with different astronomical frequencies, the amplitude of O1 varies dramatically around the globe:
| Reference Harbor | Typical Amplitude | Local Tidal Characteristics |
|---|---|---|
| San Francisco, USA | 0.38 m | Produces dramatic morning vs evening high-water differences (mixed semidiurnal). |
| Seattle / Puget Sound, USA | 0.65 m | High diurnal inequality where consecutive highs differ by more than 1.5 metres. |
| Victoria, BC, Canada | 0.55 m | Strong diurnal regime where O1 regularly overrides solar semidiurnal peaks. |
Observe how O1 interferes with other harmonic waves on our virtual brass analog synthesizer. Adjust frequency, amplitude, and phase angle interactively.
Launch Harmonic Synthesizer ›Diurnal inequality is the height difference between two consecutive high tides or two consecutive low tides in the same 24-hour day. It is caused by the constructive and destructive interference of O1 and K1 with M2.
Operators run a 48-hour dry prediction test on the chart paper to observe whether the morning-to-evening height discrepancy matches manual analytical spot checks.
Yes, during extreme tropical tides, strong O1 and K1 reinforcement can pull water levels below the standard chart datum, creating "minus tides" valuable for shellfishing and marine surveying.
The primary gravitational tide raised by the rotation of the Earth relative to the orbiting Moon twi...
The gravitational tidal force exerted by the Sun as Earth rotates once every 24 mean solar hours....
The variation in lunar distance due to the elliptical eccentricity of the Moon’s orbit as it moves b...
The declination of both the Moon and Sun north and south of Earth’s equator during their orbital cyc...